F F i i g g u u r r e e 3 3 – – N N u u r r s s e e c c a a l l l l p p e e n n d d a a n n t t p p o o r r t t a a n n d d 3 3 7 7 - - p p i i n n c c o o n n n n e e c c t t o o r r

S S e e t t t t i i n n g g u u p p i i B B e e d d W W i i r r e e l l e e s s s s ( ( o o p p t t i i o o n n ) )

W W A A R R N N I I N N G G - - Always associate or map the i i B B e e d d L L o o c c a a t t o o r r to the room or location to provide accurate location information. If

you move an i i B B e e d d L L o o c c a a t t o o r r after it has been installed and mapped, you must remap to the new room or location.

To setup i i B B e e d d W W i i r r e e l l e e s s s s :

Install the 5212 i i B B e e d d L L o o c c a a t t o o r r ™ on the wall at the head end of the product. The i i B B e e d d L L o o c c a a t t o o r r communicates with the IR

module that is installed in your product. For detailed instructions about how to mount the i i B B e e d d L L o o c c a a t t o o r r , see the instructions

for use that was included with your i i B B e e d d L L o o c c a a t t o o r r installation kit.

Contact Stryker Technical Support with any installation questions ( Contact information (page 12)).

N N o o t t e e - - You must load the wireless connection settings before the device will communicate with the i i B B e e d d Server application.

See the i i B B e e d d Server Installation and Configuration manual.

3005-009-005 Rev AA.1