Stryker S3 MedSurg Bed with StayPut Frame Mode D'emploi page 36

A Bed motion lock
B Fowler 30°+
C Patient control Fowler lock
D Patient control Gatch lock
Bed height lock
E
N N o o t t e e
• The C C P P R R button overrides all lockouts.
• The corresponding lock LED illuminates when you lock a motion control.
• The B B e e d d M M o o t t i i o o n n L L o o c c k k footboard LED indicator illuminates when you lock bed motion.
• The F F o o w w l l e e r r 3 3 0 0 ° ° + + footboard LED indicator illuminates when you lock the Fowler.
• If the product is in a specific position when a lock is enabled, the product will be locked in that position.
• Lock parameters are saved when the product is unplugged or during a power failure.
• Do not lock the control panel functions from the footboard if you must access the control panel when you remove the
footboard.
F F o o o o t t b b o o a a r r d d c c o o n n t t r r o o l l p p a a n n e e l l - - C C h h a a p p e e r r o o n n e e b b e e d d e e x x i i t t ( ( o o p p t t i i o o n n ) )
W W A A R R N N I I N N G G
• Do not use bed exit to replace patient monitoring protocol. Bed exit is intended only to aid in the detection of a patient
exiting the product.
• Do not use bed exit with patients who weigh less than 50 lb (23 kg).
EN 32
A
B
D
C
Locks all motion controls from the operator control panel and patient
control panel
Press and hold to raise and lock the Fowler at 30°.
You can raise the Fowler between 30° and 60° after you lock the Fowler
at 30°+.
Locks or unlocks the Fowler
Locks or unlocks the Gatch
Locks or unlocks the litter
E
3005-009-005 Rev AA.1