Stryker S3 MedSurg Bed with StayPut Frame Mode D'emploi page 56

I I n n f f r r a a r r e e d d ( ( I I R R ) ) m m o o d d u u l l e e ( ( o o p p t t i i o o n n ) )
A
IR (infrared) module cable
A
IR (infrared) lens
B
i i B B e e d d Locator connection LED
C
Wireless (Wi-Fi) connection LED
D
i i B B e e d d L L o o c c a a t t o o r r ( ( o o p p t t i i o o n n ) )
The i i B B e e d d L L o o c c a a t t o o r r provides the i i B B e e d d L L o o c c a a t t o o r r ID and battery status information to the IR module. See the i i B B e e d d L L o o c c a a t t o o r r
operations manual for installation and procedures for the i i B B e e d d L L o o c c a a t t o o r r .
The IR (infrared) lens (A) provides infrared communications with the i i B B e e d d IR module (Figure 56).
EN 52
B
C D
Connects to the bed and provides power and signal
communications
Provides infrared communications with the i i B B e e d d
L L o o c c a a t t o o r r
Provides connection status for the IR (infrared)
communications with i i B B e e d d L L o o c c a a t t o o r r
Slow flash - Attempting to connect to i i B B e e d d L L o o c c a a t t o o r r
Solid LED - i i B B e e d d L L o o c c a a t t o o r r connected
Rapid flash - Error condition detected
Off - i i B B e e d d L L o o c c a a t t o o r r is not trying to connect
Provides connection status for wireless (Wi-Fi)
communications with wireless access point
Slow flash - Wi-Fi attempting to connect
Solid LED - Wi-Fi connected
Rapid flash - Wi-Fi was not connected after six
minutes and timed out
3005-009-005 Rev AA.1