Télécharger Imprimer la page

Stryker S3 MedSurg Bed with StayPut Frame Mode D'emploi page 13

Masquer les pouces Voir aussi pour S3 MedSurg Bed with StayPut Frame:

Publicité

Les langues disponibles

Les langues disponibles

Channel plan
Other
C C l l i i e e n n t t d d e e v v i i c c e e d d a a t t a a u u s s a a g g e e
The client uses 10-15 KB per connected device every 40 seconds.
The client uses an additional 5-21 KB per device for each subscription that is created by a third-party vendor like
Connexall, Capsule, Epic, and Cerner.
N N o o t t e e - - Based on network conditions, device messages are typically sent in near real time or in up to five minutes while
connected. This depends on device activity like applying the brakes, adjusting the rails, alarms, and how the third-party
defines subscription times.
C C u u s s t t o o m m e e r r n n e e t t w w o o r r k k c c o o m m m m u u n n i i c c a a t t i i o o n n r r e e q q u u i i r r e e m m e e n n t t s s f f o o r r i i B B e e d d W W i i r r e e l l e e s s s s o o p p t t i i o o n n
L L A A N N e e n n v v i i r r o o n n m m e e n n t t
Client/server communication
Client device IP allocation
Server IP allocation
VLAN
I I P P t t r r a a f f f f i i c c e e n n v v i i r r o o n n m m e e n n t t
S S o o u u r r c c e e
i i B B e e d d Server
i i B B e e d d Server
i i B B e e d d Server
Third party / Stryker i i B B e e d d Wireless
Client
3005-009-005 Rev AA.1
2.4 GHz: All Channels Supported
5 GHz: All Channels Supported
(Recommend against using DFS and ISM Channels)
Leverage hospital SSID
IPv4 only
Static
DHCP
Static IP required
New, existing
P P r r o o t t o o c c o o l l / / P P o o r r t t n n u u m m b b e e r r
TCP/21
TCP/80/443
TCP/1639
TCP/80/443
Not applicable
If Static - Unique IP address will be
required for each client MAC
address
If DHCP and not using a DNS
name - Each client MAC address
will need a reserved IP address
If DHCP and using a DNS name - It
is required to create a unique name
for each client MAC address for
client management
Stryker recommends using the
Stryker client host name when
the Stryker device connects to
the wireless network - Example:
SYK-00197b12365 so it may
look like http://SYK-
00197b12365.hosp.org
Not applicable
Install i i B B e e d d Wireless on a separate
VLAN
D D e e s s t t i i n n a a t t i i o o n n
Stryker i i B B e e d d Wireless Client
Third party / Stryker back office
Stryker i i B B e e d d Wireless Client
i i B B e e d d Server
9
EN

Publicité

loading

Ce manuel est également adapté pour:

3005