Factory Setting - Wilo VeroLine IP-E Notice De Montage Et De Mise En Service

No. Designation
5.7.6.0 SBM function
5.7.7.0

Factory setting

6.0.0.0 Error acknowl-
edgement
7.0.0.0 Access disable
Installation and operating instructions Wilo-VeroLine IP-E, Wilo-VeroTwin DP-E
Type Symbol Values/explanations
Pressure value correction On
Setting for behaviour of signals
±
SBM run signal
SBM readiness signal
SBM mains On signal
OFF (default setting)
±
Settings are not changed by
confirming.
ON
Confirming will reset the set-
tings to factory settings.
Caution!
All manual settings will be lost.
For additional information, see
±
Section 11.3 "Acknowledging
errors" on page 88.
"Access disable" inactive
±
(changes possible)
(for further information, see
8.6.7 "Activating/deactivating
access disable" on page 73)
"Access disable" active (no
changes possible)
(for further information, see
8.6.7 "Activating/deactivating
access disable" on page 73)
English
Display conditions
Not displayed when
"access disable" is active
Not displayed when
"access disable" is active
Only displayed if an error is
present
79