Intended Use; Product Information; Type Key - Wilo VeroLine IP-E Notice De Montage Et De Mise En Service

English
4

Intended use

Purpose
Fields of application
Restrictions
5

Product information

5.1

Type key

52
The glanded pumps of the IP-E (in-line) / DP-E (double) series are
meant to be used as circulation pumps in building services.
They may be used for:
• Hot water heating systems
• Cooling and cold water circulation systems
• Industrial circulation systems
• Heat carrier circuits
Typical installation locations are technical rooms within the building
with other domestic installations. Installing the device directly in
other used rooms (residential and work rooms) is not intended.
Outdoor installation is not permitted for this series.
CAUTION! Risk of material damage!
Impermissible substances in the fluid can destroy the pump. Abra-
sive solids (e.g. sand) increase pump wear.
Pumps without an Ex rating are not suitable for use in potentially
explosive areas.
• The correct use of the pump/installation also includes following
these instructions.
• Any other use is considered to be incorrect use.
The type key consists of the following elements:
Example: IP-E 40/ 160-4/ 2 xx
DP-E 40/ 160-4/ 2 xx
Flange-end pump as In-line pump
IP
Flange-end pump as Double pump
DP
with Electronic module for electronic speed control
-E
40 Nominal diameter DN of the pipe connection
160 Impeller diameter
4 Motor power
2
Number of poles
Version: e.g. R1 - without differential pressure sensor
xx
WILO SE 05/2010