Burkert 8630 Instructions De Service page 97

3.3 Top Control Continuous variants
The Top Control Continuous is available in 3 forms, varying in electrical connection and control functions.
• Multipole connection with complete functions (Fig. 3.8)
• Terminal with PG cable glands and terminals with restricted functions (Fig. 3.9)
• QUICKON connection with restricted functions
External setpoint for posi-
tion or process control
4..20 mA
0..20 mA
0..10 V
0..5 V
Process control value
4..20 mA
Frequency
Pt 100
Binary input
24 V DC
Pt 100
Fig. 3.8: Position interface with multipole connections
External setpoint for posi-
tion or process control
4..20 mA
0..20 mA
0..10 V
0..5 V
Process control value
4..20 mA
Frequency
Pt 100
(as an alternative to binary
outputs)
24 V DC
Fig. 3.9: Interfaces of the TopControl Continuous on the variants with PG screw connectors and QUICKON connectors
NOTE
The Top Control Continuous posses 3-wires instruments. The 24 V DC power supply is isolated from the setpoint
signal.
96
Top Control
Continuous
(Multipole
connection)
Operating
Top Control
Continuous
(PG and QUICKON
variants)
Operating
2 binary output
Analogue position feedback
Limit switch 1 + 2
2 binary output
(as an alternative to input for
process set value)
Analogue position feedback
Advice:
Choose between an analogue
position feedback and two binary
outputs by setting the jumper.
Operating instructions no. 800607