Process Operation Level; Automatic Operating Mode - Burkert 8630 Instructions De Service

6.6

Process operation level

The process operating level is automatically set each time the unit is switched on. From configuration level you can change
over to the process operation level by using the MANUAL/AUTOMATIC key and after validation of the instruction
menu.
The process operating level allows viewing of normal control functions (AUTOMATIC mode) and to open and close the valve
manually (MANUAL mode).
Change of operating levels:
To change over between MANUAL and AUTOMATIC operating mode press the
MANUAL/AUTOMATIC key.
From MANUAL or AUTOMATIC mode you can change over to the configuration level by pressing the
5 s MANUAL/AUTOMATIC key for 5 seconds.
Returning to the process operation level, the unit operates in the last selected level before changing.
Operating mode
AUTOMATIC
MANUAL

6.6.1 AUTOMATIC operating mode

In AUTOMATIC operating mode the system functions in the process control configuration.
Key functions in AUTOMATIC operating mode:
or
or > 3 s
146
Yellow LED in
MANUAL/AUTOMATIC key
flashing
off
Display switching
Change of the process setpoint
If the additional function
Display
a quotation mark is continuously
flashing from left to right.
-
is configured and selected
Operating instructions no. 800607
of the