General Information; Symbols; Safety Information; Important For Handling - Burkert 8630 Instructions De Service

1

GENERAL INFORMATION

1.1

Symbols

The following symbols are used in these operating instructions:
indicates a working step which must be performed
ATTENTION!
Indicates information, which if not observed can result in harmful effects on the health or the serviceability of
the unit.
NOTE Indicates important additional information, tips and recommendations.
1.2

Safety information

Please observe the information in these operating instructions, as well as the operating conditions and permissible data specified
in the date sheets of the Top Control and of the relevant pneumatically actuated valve, to ensure satisfactory operation of the unit
and a long service life:
• Follow general technical rules when planning the application and operation of the unit!
• Installation and maintenance may only be performed by technical personnel provided with suitable tools!
• Note the accident prevention and safety precautions applicable for electrical units during operation and maintenance of the
unit!
• Always switch off the power supply before working on the system!
• Take suitable measures to prevent inadvertent operation or impermissible influences!
• Ensure a defined and controlled re-start of the process following an interruption of the electrical or pneumatic supply!
• We cannot accept any liability if these instructions are ignored or impermissible interventions are made in the unit and the
warranty also becomes invalid on units and accessories!
1.3

Important for Handling

ATTENTION
OBSERVE PRECAUTIONS
FOR HANDLING !
ELECTROSTATIC
SENSITIVE
DEVICES
Top Control Continuous
This electronic device is sensitive to electrostatic discharge (ESD). Contact with an
electrostatic charged person or object endangers the electronic device. The worst case
is that it will be destroyed immediately or just fail after putting into operation.
To minimize the possibility of damage by immediate electrostatic discharge, pay
attention to the requirements of EN 100 015 -1. Please also pay attention not to
assemble the electronic device while supply voltage is put on.
87