Burkert 8630 Instructions De Service page 149

B) Active process controller
The following points are shown:
• Actual process value:
• Process set point:
• Actual position of the actuator:
• Set position of the actuator after scaling
i.e. split range function or characteristic curves modification:
Internal temperature of the Top Control Continuous:
•
By pressing the arrow keys you activate the changing over between the 6 display possibilities (Fig. 6.120).
Fig. 6.20: Display, operation structure and operating instructions in AUTOMATIC mode with active process controller
NOTE When the menu item
message
The value
148
AUTOMATIC
operating mode
(> 5 s)
or
Change over
of the
Leave the key
display
Manual
operating mode
appears in the display.
indicates the previously selected safety position in %.
(-999..9999)
(-999..9999)
(0..100%)
(0..100%)
(in °C)
Configuration
Point of menu
END
or
N o
S e t t i n g
SP
a c t i v i -
o
aktive
t y
p r o c e s s
Leave the key
is active and the binary input is switched, the
Operating instructions no. 800607
f