Burkert 8630 Instructions De Service page 148

Display indications in AUTOMATIC operating mode:
A) Process controller not active
The following information from the Top Control Continuous is possible:
• Actual position of the valve actuator :
• Set position of the actuator after scaling
i.e. split range function or characteristic curves modification:
• Input signal for set position:
• Internal temperature of the Top Control Continuous:
By pressing the arrow keys you activate the changing over between the 4 display possibilities (Fig. 6.19).
Fig. 6.19: Display, operation structure and operating instructions in AUTOMATIC mode with inactive process controller
NOTE When the menu item
message
The value
Top Control Continuous
AUTOMATIC
operating mode
(> 5 s)
or
Chance over
of the
Leave the key
display
MANUAL
operating mode
appears in the display.
indicates the previously selected safety position in %.
(0..100%)
(0..100%)
(0..5/10 V or 0/4 .. 20 mA)
(in °C)
Configuration
Point of Menu
END
No activity
of the
operator
is active and the binary input is switched, the
147