Burkert 8630 Instructions De Service page 121

Description of the overview (Fig. 6.3):
After switching the power on, the Top Control Continuous is in the process operation level in the AUTOMATIC mode. To enter the
basic configuration, within the configuration level, press the MANUAL/AUTOMATIC key for a duration of 5 seconds. The submenu
will then be displayed as the first step of the main menu.
To enter the sub-menu
displayed. To move between the different functions, press the arrow keys, additionally enter any desired settings. Press the MA-
NUAL/AUTOMATIC key to validate the wished settings after selection.
NOTE The selected function is displayed on 3 or 4 digits right of the 8-characters LCD. These digits will blink on
the display.
Actfunc
Functions of the actuator
Enter in this sub-menu the configuration of the pneumatical actuator used with the Top Control . See the instrument label for
function valve description.
Input
Selected input signal
In this sub-menu enter the unit used for the setpoint value.
Addfunct
Configuration of the additional functions (see Fig. 6.4)
Omit this function during the initial operation.
120
quickly press the MANUAL/AUTOMATIC key. One of the functions of the sub-menu will be
- single acting
- double acting
- Current 4..20 mA
- Current 0..20 mA
- Voltage 0..10 V
- Voltage 0..5 V
Operating instructions no. 800607