Testing Procedures; Motor Rotation Check; Instructing The Operator - John Bean T 8026 Manuel D'utilisation

Installation Instructions
iv Testing procedures

Motor rotation check

Once the machine is hooked-up, turn the machine on
using the ON/OFF switch.
Ensure that the rotation direction of the pump is the
same as indicated by the arrow on the motor cover.
If not, reverse any two phase cables on the plug (i.e.
reverse the brown and the blue cable).
ANY DAMAGE CAUSED BY THE NON APPLICATION
OF THE ABOVE INSTRUCTIONS SHALL NOT BE
DEBITED TO THE MANUFACTURER AND WILL VOID
THE WARRANTY.
v Instructing the operator.
(Following applies only if a unit is installed by a service
Technician)
· Show the operator how to switch the unit on and
off .
Operator's Manual T 8026
72