Locking Rims - John Bean T 8026 Manuel D'utilisation

32
5-2
5-3
Operation

5.1 Locking rims

Lift the toolholder arm and move the toolholder carriage
all the way out.
Put the wheel in vertically and roll it on the footboard.
Be sure to use alloy adapters when applicable.
ATTENTION!
THE DROP CENTER OF THE RIM (WHEN IT EXISTS)
MUST BE KEPT TOWARDS THE OUTSIDE OF THE
MACHINE (Fig. 5-2).
IF THE WHEEL IS VERY HEAVY BE SURE TO
USE A SUITABLE EXTERNAL LIFTING DEVICE
(I.E. FORK LIFT, CRANE ETC.)
CHECK THAT THE WHEEL IS WELL HOOKED BY
THE JAWS OF THE CHUCK.
B E F O R E L I F T I N G F O R T H E M O U N T I N G /
DEMOUNTING OPERATIONS, ALWAYS STAND
IN A SAFE POSITION IN RELATION TO THE
WHEEL, IN ORDER TO AVOID ANY INJURIES IN
CASE THE WHEEL ACCIDENTALLY RELEASES
AND FALLS FROM THE JAWS.
Close the jaws of the chuck and move the chuck
approximately to the center of the rim. Move the
footboard toward the chuck and move the chuck up-
down while opening the chuck arms until the rim is
clamped properly (Fig. 5-3).
Operator's Manual T 8026