John Bean T 8026 Manuel D'utilisation page 52

Démonte-pneu électro-hydraulique
Table des Matières

Publicité

1
52
6-3
6-4
Maintenance
3.
Check hydraulic oil level once a month.
(Fig.6-3)
Note: Perform the check with all machine cylinders
closed.
To achieve this condition, position the parts as
indicated below.
- Turntable arm lowered
- Turntable closed
- Tool holder carriage to the right
If necessary add:
ESSO
:
Nuto H 46
SHELL
:
Tellus oil 46
TOTAL
:
Azolla 46
Oil change is not required.
4.
Clean the jaws of the chuck with a wire brush once
a week.
Note: Substitute worn or damaged jaws.
5.
Replace the light-alloy wheel protectors if worn or
damaged.
6.
Clean and grease once a month the sliding bar of the
toolholder arm (1, Fig. 6-4).
Operator's Manual
T 8026

Publicité

Table des Matières
loading

Table des Matières