Carriage Instructions; Uncrating Instructions; Moving The Machine - John Bean T 8026 Manuel D'utilisation

Installation Instructions
ii. Carriage instructions – Uncrating
instructions - Moving the machine

Carriage instructions

The machine is crated in a wooden box of appropriate
strength. The box is mounted on a pallet.
Handling of the machine must be made with an
appropriate lifting device (fork lift) (Fig.ii-1).

Uncrating instructions

Uncrate the machine paying attention when cutting
the plastic straps or during any other operation which
may be hazardous.
After removing the crate, check for any visible damage
to the machine and its components.
In case of doubt call qualifi ed personnel for assistance.
The packing materials (plastic bags, polystyrene, nails,
screws, wood etc.) must be properly disposed of. Place
the above mentioned materials into a trash container
and dispose per local regulations.
ALWAYS WEAR GLOVES WHEN UNCRATING
THE MACHINE TO PREVENT SCRATCHES OR
ABRASIONS DUE TO CONTACT WITH PACKING
MATERIALS.

Moving the machine

In case the machine is to be moved from one working
place to another, proceed as follows:
Disconnect the machine from the electric supply.
Remove from top of the cabinet and turntable all
objects that may fall during displacement and create
hazard.
Proceed as described in section iii.
Operator's Manual T 8026
66