Installation Procedures; Electric Connection; Standard Models - John Bean T7300 Manuel D'utilisation

Installation Instructions
iii Installation procedures

Electric connection

CAUTION: ANY INTERVENTION ON THE ELECTRI-
CAL SYSTEM AND THE CONNECTION OF A PLUG
(WHEN NECESSARY), MUST BE PERFORMED
ONLY BY A QUALIFIED ELECTRICIAN, IN COMPLI-
ANCE WITH THE APPLICABLE STANDARDS AND
NATIONAL LAWS AND/OR LOCAL REGULATIONS.
The standard models of the tyre changers have
electrical specifications and are supplied according to
the different power supplies that they will be connected

Standard models

to. See tables on the side.
1Ph - SmartSpeed
The electric motors operate with a voltage tolerance
(INVERTER)
equal to more or less 10%.
230 V, 1Ph, 50/60Hz, 17A
The power supply cable, which is always supplied with
the machine, must be fitted with an adequately sized
200 V, 1Ph, 50/60Hz, 20A (Japan)
type-approved plug, in compliance with the applicable
standards in the destination country.
For the installation technician
The qualified electrician, when fitting a plug, must refer
to the data clearly indicated on the plate found on the
machine electrical cable.
The user must ensure that the electrical system that the
machine is connected to, is fitted with 20 A fuses (25
A for Japan) or alternatively, an equivalent automatic
magneto-thermal switch.
Check that there is an efficient earthing system.
After the connection, press down the wheel support
rotation control pedal (1, Fig. iii-4) and check that it
rotates clockwise.
Check that the power supply system is fitted with an
automatic cut off device against overcurrents, with a
differential switch calibrated to 30 mA.
WARNING: ONLY USE TYPE B CIRCUIT BREAKERS.
1
smartSpeed
iii-4
78