John Bean T 8026 Manuel D'utilisation page 8

EAL0408G04A
EAL0408G05A
EAL0408G06A
EAL0408G07A
8
8-23562A
EAL0395G38A
EAL0395G36A
EAL0395G37A
Safety
wet surfaces.
• Plug unit into correct power supply.
• Do not remove or bypass grounding pin.
Contact with high voltages can cause death or serious injury.
EAL0408G04A (USA) - 8-23562A (EC)
Risk of electrical shock. High voltages are present within
the unit.
• There are no user serviceable items within the unit.
• Service on the unit must be performed by qualifi ed
personnel.
• Do not open any part of the unit other than noted and
allowed areas.
• Turn power switch off and unplug the unit before
servicing.
Contact with high voltages can cause death or serious injury.
EAL0408G05A (USA) - EAL0395G38A (EC)
Risk of pinching or crushing hands and fi ngers during
turntable opening and closing
• Keep hands and fi ngers clear of rim edge
during rim Mounting/Demounting on the
turntable.
• Keep hands and fi ngers out of the turntable
operating radius while it is operating
• Keep hands and other parts of the body away
from moving surfaces.
• Make sure you are familiar with all controls before
beginning any operations.
• If necessary, activate the bead breaker in stages, for
better control of its action.
• Only use approved tools.
• Do not bypass safety devices.
Contact with moving parts may cause injury.
EAL0408G06A (USA) - EAL0395G36A (EC)
Risk of pinching or crushing hands and fi ngers during
turntable rotation
• Make sure you are familiar with all controls before
beginning any operations.
• Keeps hands and other parts of the body away from
the drive belt and moving surfaces during turntable
rotation.
• Do not bypass safety devices.
Contact with moving parts may cause injury.
EAL0408G07A (USA) - EAL0395G37A (EC)
Risk of crushing.
• Always maintain a safe distance between yourself
and the wheel clamped on the turntable
• Make sure you are familiar with all controls before
beginning any operations.
• If necessary, activate the bead breaker in stages, for
better control of its action.
• Make sure that the rim is correctly clamped on the jaws.
• Only use approved tools.
Operator's Manual T 8026