Electric Installation - John Bean T 8026 Manuel D'utilisation

70
iii-2
Installation Instructions

Electric installation

THE INSTALLATION SHALL BE CARRIED OUT
ONLY BY QUALIFIED PERSONNEL AND WITHIN
THE SCOPE OF THE INSTRUCTIONS PROVIDED
IN THIS MANUAL.
Check on the plate of the machine that the electrical
specifi ca tions of the power source are the same as
the machine.
Electrical specifi cations are clearly marked on a label
at the end of the electric cord (Fig.iii-2).
Before connecting the machine to the power source,
check that the power supply has an effi cient grounding
system.
NOTE: The outlet installation must be verifi ed by
a licensed electrician before connecting
the tire changer.
Connect the electric cord of the machine with a
homologated plug.
NOTE: The yellow with green wire in the cord is the
grounding wire.
NEVER CONNECT THE GROUNDING WIRE TO A
LIVE TERMINAL.
WARNING: NEVER LAY POWER SUPPLY CABLES
OVER THE FLOOR, UNLESS PROTECTED BY AN
APPROVED COVER.
Check that the power supply has an automatic circuit
breaker with a diff erential circuit set at 30 mA.
The electric motor operates in a wide voltage range
(plus 10% - minus 7%) and frequency range (50 or 60
cycles) and has a class of insulation suitable for hot
and moist climates.
Operator's Manual T 8026