Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Electric wire rope winch BETA 2.1 EL
English
Before taking into operation, please carefully read this operating instruction.
Observe the safety instruction!
File documentation!
1
Prevention of accidents
1.1 Destined use
The electric wire rope winch BETA 2.1 EL is a power operated winch fixed to a console
for lifting and lowering of loads.
Not suitable for use in explosive danger area.
Not suitable for use in corrosive atmosphere.
Alterations to the winch or fitting of accessories are only allowed with our written approval.
Pay attention to the technical data and functional description!
1.2 Regulations for the prevention of accidents
Observe any rules which are valid for the respective country.
Presently valid in Germany:
EC directive 2006/42/EC
DGUV V54 winches- lifting and pulling devices
DGUV V52 crane
DGUV R100-500 chapter 2.8 Suspension devices in hoist operation
EN 13155 Non-fixed load lifting attachments (German version)
EN 14492-1; EN 14492-2 Power driven hoists
DIN 15020-1; ISO 16625:2013-07 Cranes and lifting appliances-Selection of wire ropes
DIN 15020-2; DIN EN ISO 4309 Cranes. Wire ropes. Care and maintenance, inspection and discard
EN 60204 T1 Electrical equipment of machines
EN 60204 T32 Electrical equipment of machines-hoists (VDE 0100 T726)
FEM 9.661, ISO 4308/1, ISO 4301/1
FEM 9.775, FEM 9.511
in the respective version
1)
1.3 Safety instructions
Operation, installation and maintenance work should only be executed by:
Competent, qualified persons
(definition of experts acc. to IEC 364) Qualified persons for reasons of their training, experience and
instruction are persons who do their necessary activities without danger and who can avoid this danger
due to their knowledge of directives, regulations for the prevention of accidents and standards. These
persons are responsible for the security of the installation.
Moving of people by the winch or staying in danger zone is forbidden.
Moving of loads over people is strictly forbidden.
Never touch moving parts.
Defects must be repaired immediately by competent trained personnel.
The load
must not be left suspended without supervision,
must not be allowed to swing
must not fall into the wire rope
must not be operated in areas which cannot be overlooked. It must be possible to overlook the entire
lifting area.
The winch
Do not exceed the capacity of each rope layer.
Before taking into operation, a competent person must check:
the lifting device
electronic overload protection system (if existing)
the load bearing parts of the structure
the carrying medium
mounting
technische Änderungen vorbehalten
design changes under reserve
04.01.601
)
1
changements techniques sous réserve
23
Publicité
Table des Matières
