Nice AVIO500 Instructions Et Avertissements Pour L'installation Et L'utilisation page 48

STEP 11
The control unit has additional special features not required for
most of standard installations. All descriptions are reported here
below.
10.1 – BACKJUMP ADJUSTMENT
This procedure allows for adjusting or eliminating the backjump.
It consists in inverting the door movement at the end of the path
to perform belt recovery, facilitate unlocking and safeguard the
mechanical system. On certain installations this is unnecessary,
therefore this value can be adjusted.
DEFAULT: backjump = value 2, equal to 500ms
Prior to proceeding with this progra mming procedure,
first verify whether either the "basic path programming" or
the "advanced path programming" have been completed.
Backjump levels: 0 / 500ms / 700ms / 1Sec / 1,5 Sec / 2Sec.
When the series consists of one flash, the backjump value is
zero (no inversion of movement at end-of-path), when there are 6
ACTION
01.
PUT THE DOOR IN THE CLOSED POSITION
02. PRESS THE START BUTTON FOR 3 SECOND
03. PRESS THE SET BUTTON FOR 1 SECOND
04. PRESS THE SET BUTTON FOR 1 SECOND
backjump value setting
EVERY TIME THE SET BUTTON IS PRESSED,
THE VALUE CHANGES FROM 1 TO 6 STARTING
FROM THE CURRENTLY SET VALUE
05.
example 1:
current backjump = 3
after SET is pressed, backjump = 4
example 2:
current backjump = 5
after SET is pressed 2 times, backjump = 1
saving of the set backjump
06. PRESS THE RADIO BUTTON FOR 2 ECONDS
PRESS THE SET AND RADIO BUTTONS
07.
SIMULTANEOUSLY
* The backjump value is indicated by the number of flashes of the series based on the set value.
22 – English
ADVANCED PROGRAMMING
1 2
6 3
5 4
flashes, the backjump is set to the maximum value.
Clearly, the other series indicate growing intermediate values from
1 to 6.
The backjump value can be known at any time after the SET
button is pressed the first time, by counting the number of flashes
of the green "photo" LED.
If the backjump value is set too high, some undesired
clearance may remain between the door and the mechani-
cal stop.
RESULT
All the LEDs turn on and then turn off (if not, consult paragraph
10.3.1)
The yellow "set" LED turns on in the fixed mode and the red
"error" LED indicates the backjump* level
The yellow "set" LED flashes then turns on in the fixed mode
and the red "error" LED indicates the backjump* level
The yellow "set" LED remains lit in the fixed mode and the gred
"error" LED indicates the backjump* level
The yellow "set" LED remains lit in the fixed mode and the red
"error" LED flashes fast
The LEDs return to the normal operation configuration