Nice AVIO500 Instructions Et Avertissements Pour L'installation Et L'utilisation page 36

3.2.2 – Fitting the gearmotor to the guide
01. Fit the AVIO500 gearmotor output shaft to the guide head [A]
and secure using 4 M6.3x38 screws [G] (fig. 14). The gear motor
rotates and can be positioned in three different ways (fig. 3).
14
G
3.2.3 – Mounting the gearmotor to the ceiling
01. On the basis of distances A in fig. 2, trace the two fixing points
of the front guide bracket at the centre of the door. On the basis
of the type of support surface, the front bracket can be fixed with
rivets, plugs or screws (fig. 15). If distances A, B and C (fig. 2 and
3) are sufficient, the bracket can be fixed directly onto the ceiling.
15
02. After drilling the holes in the relevant points, leave the gearmo-
tor head on the ground, pay attention not to damage it; then lift
the guide from the front section and position it horizontally (use a
bubble level) and fix it by using two screws, plugs or rivets, ac-
cording to the installation surface.
03. Secure the brackets [H] using the screws [I] and nuts [L], se-
lecting the hole most suited to ensure distance B, as shown in (
fig. 16)
16
L
I
04. Using a ladder, lift the gearmotor until the brackets are touch-
ing the ceiling. Trace the drilling points and then return the gear-
motor to the ground.
05. Drill at the outlined points and then, using a ladder, lift the
gearmotor until the brackets are placed against the drilled holes
(fig. 17) and secure using screws and plugs suited to the support
surface (fig. 18).
10 – English
A
B
0÷400 mm
H
17
18
06. Ensure that the guide is perfectly horizontal, then cut off the
excess section of the brackets with a saw (fig. 19).
19
07. With the door closed, pull the cord to release carriage from
the guide (fig. 20).
20
08. Slide the carriage until the door connecting bracket [N] (fig.
21) on the upper edge of the door is perfectly perpendicular to
the guide.
09. Then fix the door attachment bracket [N] with screws or rivets
(fig. 21). Use screws or rivets suitable for the door material and
check that they can support all the effort required to open and
close the door.
21
O
N