Nice AVIO500 Instructions Et Avertissements Pour L'installation Et L'utilisation page 43

ACTION
PRESS THE RADIO
BUTTON FOR 4
01. SECONDS AND R ELEASE
WHEN RADIO LED
FLASHES
PRESS THE SET BUTTON
02.
FOR 1 SECOND
PRESS A BUTTON ON
03. THE TRANSMITTER YOU
WISH TO CANCEL
3. PRESS THE RADIO
BUTTON UNTIL RADIO
04. LED TURNS OFF OR WAIT
20 SECONDS TO EXIT
THE PROCEDURE
5.7 – REMOTE (TOOLS FREE) TRANSMITTER PROGRAM-
MING
This procedure enables you to program a new transmitter without
accessing the control unit, but keeping close to it.
To run the procedure you will require a previously programmed
transmitter, to inherite its functions.
LEARNING THE OPENING AND CLOSING POSITIONS OF THE DOOR
STEP 6
PAUSE
OBSTACLE
FORCE
START
RADIO
DIP 1 & 2
To start up the system, one of the following programming
procedures must be carried out:
- basic programming of the automation's movement: self-learning
of the manoeuvre times and slowdown start points.
- advanced programming of the automation's movement: self-
learning of the manoeuvre times and manual setting of the
RESULT
The red "radio"
LED flashes (if not,
consult Paragraph
10.3.1)
The red "radio"
LED flashes and the
yellow "set" LED
turns on in fixed
mode
The red "radio"
LED flashes and the
yellow "set" LED
flashes
The red "radio" LED
and the yellow"set"
LED turn off
SET
T1
T1
slowdown start points.
If, at the start of the following procedures, the "set",
"radio" and "error" LEDs flash, it means that the programming
protection has been activated – see Paragraph 10.3.1.
To interrupt the following programming sequences at
any time, press the SET and RADIO buttons simultaneously.
6.1 – STANDARD SETTING OF THE MOVEMENT OF THE
SYSTEM
By means of this procedure, the control unit memorizes the wor-
king time and force level in order to manage the opening an clo-
sing of the system.
The slow down position in opening and closing, are set
from the CU automatically in order to guarantee the ride of
the system correctly up to the final positions of the door.
ACTION
MOVE THE DOOR TO
01.
HALF WAY POSITION
PRESS THE SET
BUTTON UNTIL THE
02. MANOEUVRING
STARTS (about 3
seconds)
RELEASE THE SET
03.
BUTTON
THE DOOR PERFORMS
04. A PARTIAL OPENING
MOVEMENT
ON A PREVIOUSLY
PROGRAMMED
T2 TRANSMITTER, HOLD
DOWN BUTTONS 1 AND
2 TOGETHER FOR 4
SECONDS
ON THE TRANSMITTER
YOU WANT TO
T2 PROGRAM, HOLD DOWN
BUTTONS 1 AND 2
TOGETHER FOR
4 SECONDS
RESULT
The yellow "set" LED
flashes (if not, consult
Paragraph 10.3.1)
The yellow "set" LED
light is permanently
on
The yellow "set" LED
light is permanently
on
English – 17