Quick Start Guide; Operation & Use; Display Screens After Switching On - Rohde ST 630 Mode D'emploi

5.2.

Quick start guide

• Switch on and wait for the kiln temperature display.
• Call up firing programs with the
• Select the firing program with the
• To start the selected program, press the
• To stop the firing at any time, press the
• The firing data and the programming mode can be called up again with the
• Change the firing data and change the displayed value with the
g
• Use the
key again as necessary to step to the next firing value or segment to be reviewed or changed.
h
• Use the
key to switch back to the previous value.
• To mark the end of a program, set the ramp rate to END with the
• To exit programming mode, either wait 20 seconds or press the
• If the keyboard is locked, press the
6. Operation & use
6.1.

Display screens after switching on

Display screens after switching on:
Indicator
Step
on the left
1
2
3
4
5
6
g
key.
f d
or key.
j
key.
j
key again.
<
key and hold it for 5 s.
Heating
Main display zone display
on the right
ROHDE
F 6.00
T/C: S
20 °C
19 °C
21 °C
57 / 317 - EN -
g
key.
f d
or keys.
f
key.
j
key to start firing.
Description
• After switching on, the controller carries out a
display test.
• All indicators light up.
•
The controller will sound a short beep.
•
The controller displays the version number of the
integrated software.
•
When contacting technical customer support, you
will need:
− the version number
−
the serial number of the device
• The thermocouple type setting is now displayed.
• This should match the type of thermocouple fitted
to the kiln and can be R, S, K or N.
• The final display shows the kiln temperature
(heating zone 1).
•
Apart from the heating zone display and the current
temperature in the main display, no indicators or
icons should light up after switching on.
The kiln temperature for the other heating zones can
f
be displayed with the
controller has been configured for a multi-zone kiln).
d
or keys (available if the