Real-Time Clock Function; Setting The Date & Time - Rohde ST 630 Mode D'emploi

10.1.5.

Real-Time clock function

• This data logger module incorporates an accurate battery-backed real-time clock to display the date and
time of day.
• It compensates for leap years.
• It does not automatically compensate for daylight saving in summer and winter.
• This clock is used to timestamp data within the data logger files. It is also used to date and time stamp
the actual file.
• Note:
The date and time stamp of the file is the time the file was last written to (not the time when the file was
first created).
• The battery is designed for a service life of around 10 years.
10.1.6. Setting the date & time
Requirements for setting:
1. Switch on the controller
2. No firing process in progress
Carry out setting:
Step Display
1
2
21.12.24
3
21.12.24
4
21.12.24
5
21.12.24
6
01.01.
7
01.01.
8
01.01.
9
01.01.
10
01.01.
11
Description
Switch on the controller
h
Press the key and hold it down for
at least 5 seconds until "Date" setting
mode appears.
Navigate to the flashing digit with the
g h
or key.
d f
Use the and keys to change
the flashing number.
Move onto the next digit with the
key.
Move to "Time" setting mode by
g
pressing the key from the flashing
day display.
Navigate to the flashing digit with the
g h
or key.
Navigate to the flashing digit with the
g h
or key.
d f
Use the and keys to change
the flashing number.
Move onto the next digit with the
key.
To exit Settings:
g
•
Press the key while the
seconds display is flashing to exit
"Time" setting mode.
•
Or wait 15 seconds.
78 / 317 - EN -
Remark
The date is shown in "YY.MM.DD"
format.
After the call-up, the numerical value for
the year flashes first.
The last numerical value for the day of
g
the current date is in the segment
display.
The time is now shown in HH.MM.SS
format.
After the call-up, the numerical value for
the hour flashes first.
The last numerical value for the second
g
of the current time is in the segment
display.
The set values are now permanently
saved. Previous entries are reseted.
⇒
The control system display goes
dark for a moment and the
control system restarts.