Mounting The Tc 304 Control Unit; Quick Start Guide - Rohde TC 304 Notice D'utilisation

Mounting the TC 304 Control Unit

Mounting the control unit on the wall
Choose a safe and easily accessible position on a wall next to the kiln to mount the
control unit.
First screw the two knurled screws into the holes indicated on the back of the
controller. They will be used later to fasten the controller in the fi xing device.
Mount the holding panel of the TC 304 control unit
using the three dowels and three screws, with one
fi xing hole pointing upwards and the other two poin-
ting downwards.
Make sure that the transparent protective foil is
correctly aligned!
Now the controller can be plugged into the fi xing
device from above. You might have to loosen the
knurled screws on the controller.
Mounting the control unit on the KE controller panel
Place the frontloader controller panel in a position that will allow the star-shaped
knob to be turned until it locks into the position indicated. When the panel is fi xed,
you can start mounting the controller on the panel.
Mount the holding bar of the TC 304 control unit using the three screws, nuts and
washers, with one fi xing hole pointing upwards and the other two pointing down-
wards.
Make sure that the transparent protective foil is correctly aligned!
First screw the two knurled screws into the holes indicated on the back of the
controller.
Now the controller can be plugged into the fi xing device from above. You might
have to loosen the knurled screws on the controller.
4 4

Quick Start Guide

Starting a program
1. Power on, the mains switch is located on the bottom of
the housing, the actual temperature is shown on the display.
2. Push the prog key once or several times to call a program.
First, the program number appears on the display, then the
end temperature is indicated.
3. Start or stop the selected program using the "Start / Stop"
key.
Note: check the set program values before each program
start.
Changing a program
1.– 2. See above
3. Use the or key to select program sections.
 
4. Change selected program section values using the
key. The values are saved automatically.

5. Start or stop the selected program using the "Start / Stop"
key.
Saving a program
The TC 304 automatically saves all the variable values of
the fi ring curve.
or

5 5