Mounting; General Safety Note; Mounting The Bracket - Rohde ST 630 Mode D'emploi

WARNING
An incorrectly placed control unit can lead to serious personal injury or property damage.
⇒ The control unit should never be placed on the kiln but should only be positioned in the
WARNING
An incorrectly connected control unit can lead to serious personal injury or property
damage.
⇒ Please make sure that you follow the specifications in this instruction manual and the
⇒ Make sure that only a properly connected control unit is put into operation.
NOTE
Do not open the device cover.
⇒ There are no user-serviceable parts inside.
4.

Mounting

4.1.

General safety note

WARNING
An incorrectly placed control unit can lead to serious personal injury or property damage.
⇒ The control unit should never be placed on the kiln but should only be positioned in the
4.2.

Mounting the bracket

• The control unit comes with a suitable mounting bracket which can be
attached to the kiln or at the operation location (near the kiln or on a wall).
• The bracket is attached with 2 screws.
• Note the direction of the arrow while the bracket is being installed
(arrow direction = up).
• Never place the control unit on the kiln but use the bracket instead.
• When mounting on the kiln, the bracket is mounted on a suitable controller
mounting plate or the switch box.
• Please refer to the operating instructions for the kiln.
• When mounting on a wall, the bracket is screwed directly to a wall near the
kiln using the fastening material supplied.
• The appropriate mounting material is included in the scope of delivery.
bracket provided for it.
operating instructions for the kiln.
bracket provided for it.
55 / 317 - EN -