Establishing Connection Manually With A Wireless Router - Rohde ST 630 Mode D'emploi

10.2.5.

Establishing connection manually with a wireless router

Process to manually connect the control unit to a wireless network using a computer, tablet or smartphone:
Step Description of the process
1 Switch the control unit off.
f
Press the key and switch on the control
2
unit.
Hold down the
3
appears in the main display.
f
4
Release the
Using a computer, tablet or smartphone,
5 manually search for a wireless network (Wi-Fi)
or access point.
A wireless network named "Controller" should
6
appear.
Connect the device to the wireless network
7
called "Controller".
Open the web browser on your computer,
8
tablet or smartphone.
Enter "192.168.100.1" in the address bar and
9
go to this address.
A list of available wireless routers is now
10
displayed in the "Wi-Fi Connection" tab.
The appropriate wireless router should now
11
appear as available in this list.
Select the wireless router in the web interface
12
and enter the access data for it.
Confirm with Save/OK and close the web
13
browser.
The controller now automatically disconnects
from the computer, tablet or smartphone
14
because a new connection to the wireless
router has been established.
Switch off the controller and switch it on again
15
immediately.
"ACCESSPT"
f
key until
key.
Remark
f
Hold down the
1) "ACCESSPT" stands for Access Point.
2) The control unit creates its own wireless network.
3) The wireless network via the access point is limited in
time and is closed each time the controller is
switched off.
⇒ The computer, tablet and smartphone need to
activate Wi-Fi and scan for new devices.
⇒ Available networks can be searched for on the
computer, tablet or smartphone in the system
settings.
⇒ The control unit and the computer, tablet or
smartphone must be in the immediate vicinity.
Ignore the following warnings from your computer, tablet
or smartphone:
­ The internet is not available.
­ This wireless network has no internet access.
Connect anyway.
­ Unsecured network
­ The process of connecting to the Wi-Fi may take a
while.
­ Similar warnings may vary depending on the device
used.
Executable with all common web browsers.
This so-called "web interface", which is now displayed
in the web browser, consists of 2 tabs, but only the
displayed "Wi-Fi Connection" tab is important for
establishing the connection.
The web interface scans for available wireless networks
in the area and displays them in a list.
You should find the access data in the documents
attached to the wireless router.
A successful connection to the wireless router is
displayed.
The controller now permanently sets up the wireless
network with the router.
⇒
If this was not successful, repeat the steps, starting
with step 1, try the connecting as described in
section 10.2.3.
The controller is now permanently connected to the Wi-Fi
router that has been set up.
81 / 317 - EN -
key while switching on.