Changing Parameters - Rohde ST 630 Mode D'emploi

12.2. Changing parameters

Step Display
1
ROHDE
2
tC. S
3
tC. S
4
P14-
5
P45-
6
0
7
3
8
3
9
10
11
P:45
12
Note:
If no button is pressed for 30 seconds, the control automatically exits the configuration menu.
in the main display and a short beep sounds for 3 seconds. Previous entries are not saved and will be lost.
Description
Switching the control unit off
j <
Press the and keys and switch on
the control system at the same time.
j <
Hold down the and
set thermocouple type is shown in the
main display.
j <
Release the and keys.
The main display shows the first
configurable parameter.
The parameter to be configured can be
d
selected by pressing the
The set value of the parameter to be
configured can be called up with the
key.
This can be altered by pressing the
d f
and keys.
The value is saved by pressing the
j <
and keys at the same time.
The control system display goes dark for
a moment and the control system
restarts.
After the restart, the control unit is ready
for operation again.
Alternatively, after step 8, press the
key to jump back to the previous menu or
to change another parameter.
87 / 317 - EN -
Remark
With older ST 630 controllers, you only
have to press the
control system at the same time.
⇒ The thermocouple type is only
keys until the
displayed and cannot be changed here.
⇒ The thermocouple is preconfigured at
the factory.
f
and keys.
You can return to the previous menu at any
g
time with the
As an example, the value from "0" to "3"
was set here for parameter no. 45 for the
additional switch output 1
(3 = control of a cooling system using a fan
on the kiln).
The set value is now permanently saved for
the respective parameter.
h
Repeat steps 6 to 12.
j
key and switch on the
h
key.
„TIMEOUT!"
is shown