Quick Start Guide - Rohde ST 630 Notice D'utilisation

4. Quick Start Guide

• Switch on and wait for kiln temperature display.
• To run a fi ring program, press the
• To select a fi ring program, press the
• To start the selected program, press the
• To stop the fi ring at any time, press the
• To review fi ring data, press the
• To change fi ring data, press the
• Use the g key again as necessary to step to the next fi ring value or segment
to be reviewed or changed.
• To mark the end of a program set a ramp rate
to with the
END f
• To exit the programming mode either wait
20 seconds or press the
• If the keyboard is locked, then press the
and hold down for 5 seconds to unlock.
g key.
d
g key to enter the programming mode.
and
d
key.
j key to start fi ring.
or f key.
key.
j
j key again.
keys to change the displayed value.
f
key
<
23