Side stand (fig. 23)
Important
Before lowering the side stand, make sure that the
bearing surface is hard and flat.
Do not park on soft or pebbled ground or on asphalt
softened by the heat or the motorcycle may fall over.
When parking in downhill road tracts, always park the
motorcycle with its rear wheel facing downhill.
To pull down the side stand, hold the motorcycle
handlebars with both hands and push down on the thrust
arm (1) with your foot until it is fully extended. Tilt the
motorcycle until the side stand is resting on the ground.
Warning
Do not sit on the motorcycle when it is supported on
the side stand.
To move the side stand to its rest position (horizontal
position), tilt the motorcycle to the right and, at the same
time, lift the thrust arm (1) with your foot.
Note
Check for proper operation of the stand mechanism
(two springs, one into the other) and the safety sensor (2)
at regular intervals.
Note
It is possible to start the engine with side stand down
and the gearbox in neutral. When starting the bike with a
gear engaged, pull the clutch lever (in this case the side
stand must be up).
2
1
fig. 23
E
29