Installation And Mounting; Selecting The Assembly Location - SICK UE4215 Notice D'instructions

Les langues disponibles

Operating Instructions

UE4215

Installation and mounting

8010654/TF83/2010-07-20

Subject to change without notice

Installation and mounting

This chapter describes the preparation and completion of the installation of the safe bus

node UE4215. The installation and mounting requires the following steps:

Selection of a suitable assembly location (cf. chapter 4.1 "Selecting the assembly

location")

Mounting on a base with functional earthing (cf. chapter 10.2 "Accessories"), if the

ESPE connected requires functional earthing

4.1

The safe bus node UE4215 is a decentral component. Select a suitable assembly location

on the basis of the following criteria:

Mounting position in the immediate vicinity of the hazardous point to be protected

Short cable paths to the components to be connected

Flat assembly surface to enable the housing to be assembled without becoming

distorted

Diagnostic LEDs of the device visible, simple device exchange

Protected in order to prevent any removal or breakage of the connecting wires by

personnel or the device

Sufficient space for the plug connections

With respect to vibrational and impact load, temperature and humidity, suitable in

accordance with the data in chapter 9 "Technical specifications".

Chapter 4

Table des Matières