SICK UE4215 Notice D'instructions page 107

Operating Instructions
UE4215
8010654/TF83/2010-07-20
Subject to change without notice
Annex
11.2 Manufacturer's checklist
Checklist for the manufacturer/installer for the installation of the safe bus node
Details about the points listed below must be present at least during initial commissio-
ning — they are, however, dependent on the respective application, the specifications of
which are to be controlled by the manufacturer/installer.
This checklist should be retained and kept with the machine documentation to serve as
reference during recurring tests.
1. Have the safety rules and regulations been observed in
compliance with the directives/standards applicable to the
machine?
2. Are the applied directives and standards listed in the
declaration of conformity?
3. Does the protective device fulfil the required PL/SILCL and
PFHd according to EN ISO 13 84971/EN 62 061 and the type
according to EN 61 49671?
4. Are the required protective measures against electric shock in
effect (protection class)?
5. Has the protective function been checked in compliance with
the test notes of this documentation?
In particular
– Function test of the sensors connected to the safe bus
node
– Cut-off path test
6. Is it ensured that after every configuration change to the safe
bus node, a complete test of the safety functions is
performed?
This checklist does not replace the initial commissioning, nor the regular inspection
by qualified safety personnel.
© SICK AG • Industrial Safety Systems • Germany • All rights reserved
UE4215 for AS3interface
GB
Chapter 11
Yes No
Yes No
Yes No
Yes No
Yes No
Yes No
107