DJO Global ARTROMOT-SP3 Mode D'emploi page 23

. Description of the ARTROMOT®-SP
The motorized CPM device provides the
following passive motion to the ankle joint:
plantar flexion / dorsal extension
50° / 0° / 40°
inversion / eversion
40° / 0° / 20°
It can be reconfigured for use on either
side and allows patients to exercise in bed
and while sitting on a chair.
Note!
To unambiguously represent the current
position of the CPM device, the values
for plantar flexion and inversion are
marked with the symbol „-" both on the
display and in this document.
These are some of the ARTROMOT®-SP
features:
– anatomically correct setup
– physiological movements
– programming unit for precise adjust-
ment of patient-specific therapy values
– symbols for easy operation of the pro-
gramming unit
– chip card for storage of the programmed
therapy parameters
Biocompatibility
Those parts of the ARTROMOT®-SP
device that come into contact with the pa-
tient when the device is used as intended,
are designed to fulfil the biocompatibility
requirements of the applicable standards.
. Description of the device
components
Note: Please fold out page ΙΙΙ !
1. Clamping levers to adjust the height of
the calf support assembly
2. Calf support assembly
3. Motor A (center of rotation for dorsal
extension/plantar flexion)
4. Bracket for programming unit
5. Clamping lever to adjust the inclina-
tion of the carriage
6. Aiming pin for adjustment of the rota-
tional axis of the upper ankle joint
7. Footplate
8. Knurled screw for adjustment of the
footplate height
9. Knurled screw to adjust the footplate
to the leg length
10. Motor B
11. Footplate bracket
12. Thumbscrew to secure motor B on the
moving bracket for dorsal extension /
plantar flexion
13. Bore hole to mount motor B to the
moving bracket for dorsal extension/
plantar flexion
14. CPM base
15. Moving bracket for dorsal extension/
plantar flexion
16. Power switch (ON/OFF)
17. Fuse cap
18. Connection for power cord
19. Locking device to adjust the height of
the carriage
20. Perforation to set the height of the
carriage
21. Patient chip card1
22. Programming unit
23. Nameplate
24. Connection for programming unit
. Description of the programming unit
. . Programming unit in normal mode
patient chip card¹
set angle of motor A
current position of motor A
(arrow pointing up =
dorsal extension
arrow pointing down =
plantar flexion)
selected therapy
protocol
set dorsal
extension value
set plantar
flexion value
motor A - selected
direction of motion
"+" key
"-" key
¹Devices of the ARTROMOT®-SP3 product family with patient chip card only.
set angle of motor B
current position of
motor B
(left or right - solid foot
symbol / arrow pointing
inward = inversion
arrow pointing outward
= eversion)
therapy timer
set eversion value
set inversion value
motor B - selected
direction of motion
parameter keys
MENU key
START key
STOP key