Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2
Operation
2.6.2 Coding Switches for the
Sound Effects Circuit
The sound effects circuit also has
8 coding switches, which are used
to change different sound effects.
Caution:
These switches come from the factory
set in the optimal combination of on
and off settings. Changing them is
therefore not necessary. In extreme
cases changing the settings for these
coding switches can damage the
sound effects circuit.
Switch settings done at the factory:
Switch
1
2
3
4
5
6
7
on on on off on off on on
32
The following table shows the settings for the coding switches for your information:
No.
Switch at on
1
Must always be set at "on"!
2
Must always be set at "on"!
3
The sound effects are turned off after a few minutes
as long as the locomotive is at a standstill and all (!)
functions are shut off.
4
Different additional sound effects (air compressor,
work sounds of the fireman, etc.) activated.
5
Must always be set at "on"!
6
Tyical flat slide valve noise can be heard during
coasting.
7
Reproduction of different sound effects, depending
8
on the operating status of the locomotive.
8
Reproduction of 4 exhaust strokes per wheel revo-
lution (the same as the original).
Switch at off
Must never be set at "off"!
Must never be set at "off"!
Automatic shutoff deactivated.
Additional sound effects not activate.
Must never be set at "off"!
Setting for locomotives with round slide valve.
The same sound effects of the locomotive in opera-
tion, regardless of its operating status.
Reproduction of only 2 exhaust strokes per wheel
revolution (for operation of the locomotive at very
high speeds).
Publicité
Table des Matières
