marklin Baureihe 01 Manuel page 23

2
Operation
2.3 Selecting the Type
of Voltage for Power
Only necessary with operation with
AC or DC power.
1. Remove the tender insert
(see page 61).
Left setting: DC power
Right setting: AC power
Important: Switch 10 (0) of the
coding switches on the digital elec-
tronic circuit must remain at "off".
24
2.4 Setting the Maximum
Speed and the Accele-
ration / Braking Delay
1. Remove the tender insert
(see page 61).
There are two potentiometers on
the electronic circuit plate which are
used to change the locomotive's
maximum speed or acceleration and
braking delay. The braking delay
works only with digital operation.
Potentiometer 1 (P 1):
Acceleration and braking delay are
changed at the same time.
Turning to the left: minimum delay
Turning to the right: maximum delay
Potentiometer 2 (P 2):
Setting for maximum speed
Turning to the left: lowest maxi-
mum speed
Turning to the right: highest maxi-
mum speed
The highest maximum speed and
a medium acceleration and braking
delay are set at the factory.
The load-dependent speed control
functions automatically. Technically
this control is more apparent in the
"digital" operation setting than in the
settings "AC power" or "DC power".