marklin Baureihe 01 Manuel page 24

2.5 Operation with the Various
Power Systems
2.5.1 Digital / Delta Operation
Suitable central unit for digital opera-
tion: Märklin 6021 Control-Unit.
Important:
Required setting for the coding
switches on the back of the
Control-Unit:
Switch: 1 2 3
Variation 1: on on on
Variation 2: off on off
Operation with the earlier
Central-Unit (6020):
Functions f1 through f4 cannot be
used. No direction of travel indicator.
Suitable Delta controller:
Delta-Station (6607).
2.5.1.1 Setting Digitial / Delta
Address.
Decoder 1
(locomotive decoder in the tender):
1. Remove the tender insert
(see page 61).
2. Set the coding switches on the
digital decoder for the desired
address according to the table
on this page.
4
off
Decoder 1 in this model comes from
the factory set for address 01.
off
Hence, these switch settings:
Switch
1 2 3 4 5 6 7 8 9 0
off on on off on off on off off off
Important:
Do not confuse the address switches
on the digital decoder with the 8 co-
ding switches on the sound effects
circuit. If these 8 coding switches are
accidentally changed, it may cause
damage in the electronic circuit!
Switches 9 + 10 (designated with 0)
must always be set at "off".
Suitable Delta addresses:
24, 60, 72, or 78.
Decoder 2
(function decoder in the locomotive):
1. Loosen the pilot truck on the front.
The function decoder for the loco-
motive is located under it in the
locomotive (see page 62).
2
Operation
2. Set the coding switches on the
digital decoder for the desired
address according to the table on
this page.
Important: The function decoder only
has 8 coding switches. Only these
8 switches from thet table are there-
fore relevant for setting the address.
Tip: The upper part of the packaging
for the locomotive can serve as a
cradle for it.
Decoder 2 in this model comes from
the factory set for address 02.
Hence, these switch settings:
Switch
1 2 3 4 5 6 7
off off on off on off on off
8
25