Camera Dialog: General Notes And Sivision 3 Operating Modes; Camera Dialog: Video Mode - Sirona C1+ Notice D'utilisation

17 SIVISION 3 / SIROCAM 3 / SIROCAM C

17.3 Camera dialog: General notes and SIVISION 3 operating modes

17.3
Camera dialog: General notes and SIVISION 3 operating modes
17.4

Camera dialog: Video mode

64
The camera dialog of the dentist panel opens after the
SIROCAM 3 / SIROCAM C3 is removed from instrument
holder 6 or from the additional instrument holder.
The camera can be operated by the unit foot switch if no
other instrument is active (removed and operable by foot
switch) when the camera is removed.
i
NOTE
The camera dialog can also be called up:
– with the left dialog change key
of the assistant dialog,
regardless of whether the camera is removed.
This is possible on the dentist panel and the assistant
panel (see page page 22).
The camera dialog does not close when the camera is
deposited. Even with the camera deposited, various
camera and PC functions can be used.
It is closed only after the foot switch is pressed forward
or the dialog is terminated in any way. No image
changes occur in this case.
The camera dialog is dependent on the operating
mode.
• In Video mode, the video functions can be used in-
dependently of a PC. Up to four images can be
saved.
• In the PC mode, the video function depends on a
connected PC and the software installed on it (e.g.
SIDEXIS/VIDEXIS).
Removing the camera
• If STILL IMAGE or QUAD IMAGE was displayed
with the camera set down it its holder, this display is
retained.
• If BLACK IMAGE or WHITE IMAGE was displayed
with the camera set down in its holder, the preceding
display status corresponding to the BLACK or
WHITE IMAGE appears.
LIVE, STILL or QUAD IMAGE.
A
Switching from STILL IMAGE to LIVE IMAGE
Actuate foot switch in direction A
i
NOTE
*
The foot switch functions A and B can be reversed on
request by the service engineer.
Sirona Dental Systems GmbH
*
– cursor upwards.
59 06 446 D 3386
D 3386.201.01.08.02