Sirona C1+ Notice D'utilisation page 130

11 Programming automatic positioning
S
1
3
5
P
#
S
34
0
C
2
4
6
12:45
0
C
C
When programming is completed, the Chair program
dialog automatically appears on the display again.
Preselect by activating sitting or standing
dentist (see page page 20).
Brief actuation of the desired program causes the treat-
ment center to travel into the treatment position you
selected. The unit lamp then switches ON (if pro-
grammed).
If the lamp is programmed OFF, e.g. in program 0, S, P
etc., the lamp switches off before the treatment center
moves into the treatment position.
If the program is activated for a longer period of time, the
arrow symbol
appears in the center of the odontogram and the treat-
ment center returns to its factory-set position.
If the factory-set examination position is reprogrammed
in the Neutral dialog, (foot switch at the front, A, or, if
exchanged, at the rear, B) the factory setting is overwrit-
ten.
Programming key S
The tumbler filling and cuspidor flushing functions can
be programmed at the same time.
• Actuate the S key in the Chair program dialog. If re-
quired, change the positions of the chair and the
dentist element manually as described in the chair
setting dialog (see page page 29).
• In the Chair program dialog,
select the assistant dialog.
• Activate automatic tumbler filling or / and cuspidor
flushing.
• Call up the manual chair setting dialog and save it
with the programming key.
CAUTION
IMPORTANT: Tumbler filling and cuspidor flushing must
still be activated while the program is saved.
On selection of this tumbler filling position the also pro-
grammed functions of tumbler filling / cuspidor flush-
ingg switch on automatically.
Sirona Dental Systems GmbH
59 06 446 D 3386
D 3386.201.01.08.02