Installing An External Transducer - MINN KOTA RIPTIDE TERROVA Manuel Du Propriétaire

Installing an External Transducer

Your trolling motor may be pre-installed with a Universal Sonar transducer system. For compatibility and more information on
Universal Sonar, please visit minnkotamotors.com. An external transducer is not included with your trolling motor. An external
transducer can be installed onto the motor.
1
a. Mount the External Transducer according to
directions provided with the transducer.
b. Leave enough slack in the Transducer Cable
between the Lower Unit and Control Head to
allow the motor to properly stow and deploy.
c. Use two tie wrap cables to secure the Transducer
Cable to the Shaft just above the Lift Assist Collar
and just below the Control Head.
d. Run the Transducer Cable through the Coil Cord
to the power supply.
CAUTION
Not following the recommended wire routing for the
Universal Sonar may cause damage to the product and
void your product warranty. Take care to test the length
and placement of cable to be sure that there is enough
slack where needed and that cables are free of being
entangled in moving parts. Routing the cables in any way
other than directed may cause damage to the cables by
being pinched or severed.
©2016 Johnson Outdoors Marine Electronics, Inc.
INSTALLING AN ExTERNAL TRANSDUCER
Control Head
Coil Cord
Transducer Cable
Lift Assist Collar
External Transducer
Tie Wrap Cable
Slack
Tie Wrap Cable
Lower Unit
minnkotamotors.com | 27