MINN KOTA RIPTIDE TERROVA Manuel Du Propriétaire page 33

3
d. Reassemble the remote. Begin by removing the
board from the front of the remote case. This is
the same board that holds the battery. Leave the
Keypad in place on the front of the remote.
e. Note that the alignment peg in the back of
remote case must line up with the corresponding
alignment hole in the circuit board. Place the
board with the battery facing down on the back of
the remote case.
4
f. Position the back of the remote case so that
the Alignment peg is towards the top when the
remote is laying on a flat surface. Position the
front of the remote case so the keypad and the
curved buttons are towards the bottom when the
remote is laying on a flat surface.
g. Keep the back of the Remote Case flat. Place
the front of the Remote Case, with the Keypad is
place, on the back of the Remote Case. Make sure
the Case is seated.
5
h. Reinstall the four case screws and tighten them
as required.
©2016 Johnson Outdoors Marine Electronics, Inc.
3f
Remote
Case Front
Battery
3g
Battery
Retaining
Fingers
Alignment
Remote
Case Front
Alignment
Keypad
COPILOT
Retaining Fingers
Case Back
Peg
Case Back
Peg
Circuit
Board
Screws
minnkotamotors.com | 33
Remote
Remote