MINN KOTA RIPTIDE TERROVA Manuel Du Propriétaire page 14

i
ROUTING THE -PILOT LINK CABLE
1
a. Place the motor in the deployed position.
b. Locate the i-Pilot Link cable, at the base of the
Control Head.
CAUTION
Not following the recommended wire routing for the
i-Pilot Link cable, if equipped, may cause damage to the
product and void your product warranty. Route cables
away from pinch points or other areas that may cause
them to bend in sharp angles. Routing the cables in any
way other than directed may cause damage to the cables
by being pinched or severed.
c. The i-Pilot Link cable should be fed all the way
through the Coil Cord. It should exit the Coil Cord
at the bottom of the Coil Cord, where it connects
to the Mount.
14 | minnkotamotors.com
Control Head
i-Pilot Link
Coil Cord
Mount
NOTE: After the i-Pilot Link Cable exits the Coil
Cord, it should be routed through an established
routing system on the boat, in an area with minimal
interference. Inspect the selected route carefully to
ensure that there are no sharp edges, obstacles, or
obstructions that may damage the cables.
©2016 Johnson Outdoors Marine Electronics, Inc.