Installing An External Transducer - MINN KOTA RIPTIDE TERROVA Mode D'emploi

INSTALLING AN EXTERNAL TRANSDUCER

An external sonar transducer can be installed onto the motor as shown.
1. Transducer cables should be routed through the coil cable as
depicted in the illustration to the right.
2. Leave enough slack for proper stow and deploy.
3. Mount transducer according to transducer instructions.
Note: An external transducer is not included with your trolling motor.
Your trolling motor may be pre-installed with a Universal Sonar 2
transducer system. In this case, the transducer is integrated into the
motor unit.
For compatibility and more information on Universal Sonar 2, please
visit minnkotamotors.com/us2.
ACCESSORY RECOMMENDATIONS:
• Minn Kota Transducer Mounting Kit (MKR-15)
©2015 Johnson Outdoors Marine Electronics, Inc.
USING & ADJUSTING THE MOTOR
Tie wrap cable Tie wrap cable
Leave slack Leave slack
Transducer Transducer
cable cable
Leave slack Leave slack
Tie wrap cable Tie wrap cable
Transducer Transducer
minnkotamotors.com | 13