Routing The I-Pilot Link Cable - MINN KOTA RIPTIDE TERROVA Manuel Du Propriétaire

9
o. Replace the four sideplate screws using a #3 or
#2 Phillips screwdriver. Two of these screws will
be located on each side of the mount.

Routing the i-Pilot Link Cable

Your trolling motor will also be pre-installed with either i-Pilot or i-Pilot Link. To learn more about the GPS capabilities
available with your i-Pilot or i-Pilot Link navigation system, please refer to the corresponding Owner's Manual by visiting
minnkotamotors.com.
The i-Pilot Link features require a cable to be connected to an output device. This connection is present on the trolling motor
below the Control Head, if installed. The i-Pilot system does not need an external wired connection. If only one connection
is present, your motor is equipped with the i-Pilot Link system. If no connections are present, your motor may or may not be
installed with i-Pilot. Please follow the Minn Kota recommendations on routing the cables to optimize mobility and maximize
functionality. The routing will be the same regardless of the number of cables present. Use the following instructions to properly
route cables.
Cables are shielded to minimize interference. To protect this
shielding the cables should not be pulled tight against sharp
angles or hard objects. If using cable ties, do not over-tighten.
Any excess cable should be bundled in a loose loop of no less
than 4" in diameter.
To minimize trolling motor interference, ensure that the fish
finder and trolling motor are powered by separate batteries.
Please refer to the Battery & Wiring Installation and Motor
Wiring Diagram sections of this manual for correct
rigging instructions.
©2016 Johnson Outdoors Marine Electronics, Inc.
ROUTING THE -PILOT LINK CABLE
i-Pilot Link Cable
Locking Collar
i
Sideplate Screw
Eight Pin Connector
i-Pilot Link Cable from
Control Head
minnkotamotors.com | 13