Audio Modes - MINN KOTA RIPTIDE TERROVA Manuel Du Propriétaire

Masquer les pouces Voir aussi pour RIPTIDE TERROVA:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

COPILOT

AUDIO MODES

There are three receiver Audio Modes available. The unit is factory set to Audio Mode 2. To switch from one audio mode to
another, simultaneously press and hold the increase and decrease speed buttons for one second. The receiver will respond with
1, 2 or 3 audible beeps indicating the corresponding receiver audio mode change.
Audio Mode
Function
All of the normal audible sounds mentioned in this owners manual, but no audible beeps for speed increase/
Mode 1
decrease or prop on/off.
Mode 2
Same as audio mode 1 plus an audible beep for speed increase / decrease and prop on/off.
Mode 3
Same as audio mode 2 plus the prop on audible tick every 1.5 seconds.
NOTE:
When the Foot Pedal is operating the motor and the propeller is on, the prop on indicator tick will be heard if the
receiver is set to Audio Mode 3.
Audio Pattern
1 Beep
1 Beep
2 Beeps
Single tick every 1.5 seconds
1 Beep
2 Beeps
3 Beeps
1 Chirp
2 second long Beep
5 Beeps
Steady Tone
4 Beeps
Ten second warbling sound that
transitions into a steady tone
1 long Beep, 2 short Beeps, pause
(repeat)
30 | minnkotamotors.com
What Condition Causes Audio Pattern
Pressing the Increase Speed or Decrease Speed button
Pressing the Prop ON/OFF button to turn the Prop on
Pressing the Prop ON/OFF button to turn the Prop off
When the Prop is active including when Speed is set to 0
Switching to audio Mode 1
Switching to audio Mode 2
Switching to audio Mode 3
Every time the receiver is powered up and there is at least one remote learned
Every time the receiver is powered up and there are no remotes learned
Foot pedal speed control is moved after speed has been adjusted with remote
Heard while holding down the Learn button on the receiver
Heard after a remote button is pressed while the receiver learns it.
Heard during the process used to clear all stored remotes after the learn switch is released,
a 2 second long beep will be heard
Powered up with Momentary/Constant Switch in the CON position (or the Momentary
Button held) when the Foot Pedal is moved to momentary, the power up audio will be
heard
Audio Mode
Modes 2 and 3
Modes 2 and 3
Modes 2 and 3
Mode 3
All
All
All
All
All
All
All
All
All
All
©2016 Johnson Outdoors Marine Electronics, Inc.

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Riptide terrova 55Riptide terrova 80Riptide terrova 112

Table des Matières