MINN KOTA RIPTIDE TERROVA Manuel Du Propriétaire page 10

INSTALLING THE RIPTIDE TERROVA
2
c. Remove the Right Sideplate.
d. Swing the Left Sideplate out and away from the
Base Extrusion.
2c
3
e. Make sure that the Power Cables from the
battery are disconnected, or that the breaker,
if equipped, is "off".
WARNING
Make sure the motor is mounted on a level surface and is
not connected to a power source.
4
f. Place the mount as close to the centerline or
keel of the boat as possible. The motor can
be installed on either the Port or Starboard
side of the boat based on personal preference.
Check placement with the motor in the stowed
and deployed positions. Review the mounting
considerations at the beginning of the installation.
10 | minnkotamotors.com
Right Sideplate
2d
Base Extrusion
Left Sideplate
Power Cables
Keel
Deck of Boat
©2016 Johnson Outdoors Marine Electronics, Inc.