Installing An External Transducer - MINN KOTA Terrova Manuel Du Propriétaire

INSTALLING AN EXTERNAL TRANSDUCER

INSTALLING AN EXTERNAL TRANSDUCER
An external transducer is not included with your trolling motor. An external transducer can be installed onto motors that have Universal
Sonar or motors that do not have a built in transducer. For more information on Universal Sonar, please visit minnkotamotors.com.
Installing an external transducer is not recommended for motors with Built-in MEGA Down Imaging.
1
a. Mount the External Transducer according to
directions provided with the transducer.
b. Leave enough slack in the Transducer Cable
between the Lower Unit and Control Head to allow
the motor to properly stow and deploy.
c. Use two tie wrap cables to secure the Transducer
Cable to the Shaft just above the Lift Assist Collar
and just below the Control Head.
d. Run the Transducer Cable through the Coil Cord to
the power supply.
CAUTION
Not following the recommended wire routing for the
Universal Sonar and External Transducer Cables may cause
damage to the product and void your product warranty. Take
care to test the length and placement of cable to be sure
that there is enough slack where needed and that cables are
free of being entangled in moving parts. Routing the cables
in any way other than directed may cause damage to the
cables by being pinched or severed.
32 | minnkotamotors.com
Control Head Control Head
Coil Cord Coil Cord
Transducer Transducer
Cable Cable
Lift Assist Collar Lift Assist Collar
External Transducer External Transducer
©2022 Johnson Outdoors Marine Electronics, Inc.
Tie Wrap Tie Wrap
Cable Cable
Slack Slack
Tie Wrap Tie Wrap
Cable Cable
Lower Unit Lower Unit