Proper Use - Spencer Fixo Kid Instructions D'utilisation

• Product cleanliness
• Absence of cuts, holes, tears or abrasions on the entire structure
• Conditions of wear of the device.
• Check that the buckles are working properly.
Do not modify the device or its parts for any reason as this could cause damage to the patient and/or rescuers.
Failure to take the above measures will preclude safe use of the device, resulting in risk of damage to the patient, operators and the device itself.
For subsequent use, perform the operations specified in paragraph 11.
If the above conditions are met, the device may be considered ready for use; otherwise, you must immediately remove the device from service and contact the Manufacturer.
Do not alter or modify the device arbitrarily, as doing so could result in unpredictable operation and damage to the patient or rescuers and will void the warranty and
release the Manufacturer from all liability.

10. PROPER USE

Primary medical evaluations must be carried out before intervening on the patient.
Before using Fixo Kid, carefully read the instructions for the device with which it is to be used.
7. Reposition the strap around the stretcher back in such a way that it is perpendicular to the stretcher's perimeter frame.
8. Fasten the lateral straps (no. 6 section 8) to the stretcher frame over the side rail and adjust the tension so that they are of equal intensity on both sides and to ensure
the device is not moving.
9. Fold the groin strap over the patient's abdomen, ensuring that the padded part is well positioned.
10. Pass the patient's arm through the gap between the right chest belt and the right shoulder belt (No. 5 and No. 3 section 8 respectively), then insert the half-buckle (No.
11 section 8) into the central buckle (No. 10 section 3.2).
11. Repeat the same operation for the left side.
12. Ensure that the two half-buckles are correctly coupled and inserted.
13. After checking that the padded parts are properly positioned to ensure the patient's comfort, adjust the tension of all the belts (shoulder, chest and groin) to achieve
an effective retention system.
14. To remove the patient from the device, use the two red buttons on the half-buckles and remove the groin, chest and shoulder straps from the patient's body. Then lift
the patient out of the device according to emergency procedures.
Before using the device, perform all the preliminary checks set out in these ope-
rating instructions.
1. Remove any standard straps from the stretcher.
2. Raise the stretcher backrest to an angle between 15 and 45 degrees.
3. Place Fixo Kid on the mattress with all straps extended.
4. Centre the device with respect to the mattress edges.
5. Encircle the stretcher's backrest with the stretcher strap and fasten the buckle.
Leave a minimum amount of slack during this phase
6. Position the patient on the device
IT
EN
DE
FR
ES
PT
RO
13