Stryker GoBed II MedSurg Bed FL28C Guide D'utilisation page 31

Three Function Pendant Control - FA64141
This button-type pendant control for the patient and nursing staff may be hooked on to the siderails . It is used to raise
and lower the bed, and to raise and lower the head and foot sections .
WARNING
The scale and bed exit systems must be adjusted if this accessory is added when either system is in operation . Refer to
the "Add / Remove Equipment" procedure
INSTALLATION
Tools Required:
• None
Procedure:
1 . Plug the cable connector into the socket under the center section on either side of the bed .
2 . Tighten the connector lock ring .
3 . Hook the pendant control on to the siderail .
OPERATION
Lock ring
www.stryker.com
(page 1-21) .
Raise head section
Raise bed
Raise foot section
Cable connector
280C-009-001 REV B
Lower head section
Lower bed
Lower foot section
Return To Table of Contents
1-29