Stryker GoBed II MedSurg Bed FL28C Guide D'utilisation page 43

Removable I.V. Pole, 1" - FA61002-G
The removable I . V . pole FA61002 is a 1" diameter I . V . pole with and adjustable height . The base of the pole is equipped
with a lock pin to prevent the pole from rotating when installed in a socket .
WARNING
The scale and bed exit systems must be adjusted if this accessory is added when either system is in operation . Refer to
the "Add / Remove Equipment" procedure
INSTALLATION
Tools Required:
• None
Procedure:
1 . Insert the I . V . pole into one of the sockets located on the four corners of the bed .
2 . Rotate the pole to until the lock pin engages in the socket .
OPERATION
CAUTION
Do not use the I . V . pole as a push/pull device .
1 . To adjust the height of the pole:
• Turn the locking sleeve counterclockwise and raise the telescoping portion
of the pole to the desired height .
• Tighten the locking sleeve .
2 . Hang the I . V . bags .
WARNING
The weight of the I . V . bags must not exceed 11 lb (5 kg) per hook .
www.stryker.com
(page 1-21) .
280C-009-001 REV B
Tightening Sleeve
Return To Table of Contents
1-41